Knitting · Starting off
CO: Cast on (long-tail)
Putting the first stitches on the needle. The long-tail cast on is the one most patterns mean when they only say cast on: it is quick, neat and stretchy.
- Stitch count
- Each loop put on the needle is one stitch.
- Also written
- cast on, LTCO
How to work it
- Pull out a tail about three times as long as the edge will be wide. Make a slip knot there and put it on the needle: that is the first stitch.
- Hold the needle in your right hand. With your left hand, hang the tail over your thumb and the yarn from the ball over your index finger, and hold both strands in your palm.
- Bring the needle tip up under the strand on the outside of your thumb.
- Take the tip over the strand on your index finger and catch it.
- Bring the caught strand down through the loop on your thumb.
- Let the loop slide off your thumb and snug the new stitch on the needle by pulling the tail with your thumb.
- Repeat from the third step until the needle holds the number of stitches the pattern asks for.
Good to know
- The slip knot counts as the first stitch.
- If the edge comes out tight, leave a little space between the stitches on the needle, or cast on over a needle one or two sizes larger. The space between stitches is what lets the edge stretch.
- Running out of tail before the last stitch is the usual mishap. When in doubt, pull out more: a tail that is too long costs only a little yarn.