Skip to content
Rowly
All stitches

Knitting · Starting off

join in the rnd: Join in the round

Closing a cast on into a ring so that the piece is knitted as a tube. Patterns say to join to work in the round, being careful not to twist.

Stitch count
The stitch count stays the same.
Also written
join to work in the round, join in the round, join, being careful not to twist

How to work it

  1. Cast on the number of stitches the pattern asks for, on a circular needle or on double-pointed needles.
  2. Lay the needle down and turn the stitches so that the cast-on edge runs along the inside of the ring, all the way around. Where the edge crosses over the needle, it is twisted.
  3. Pick the needle up with the last stitch cast on, the one the working yarn hangs from, at the right-hand tip.
  4. Slip a marker onto the right needle. It marks the start of the round.
  5. Knit the first stitch on the left needle, which is the first one you cast on, and pull the yarn snug. The ring is closed.
  6. Carry on around. When you reach the marker, slip it and begin the next round.

Good to know

  • Check again at the end of the first round. A twist found then can still be turned out at the join. After that the only cure is to start over.
  • For a neater join, cast on one stitch more than the pattern says. Slip it to the left needle and knit it together with the first stitch.
  • In the round the right side always faces you. Knitting every round gives stockinette, with no purl rows.

Reading a pattern?

Rowly keeps your place in the pattern, row by row.

Try Rowly