Skip to content
Rowly
All stitches

Knitting · Basic stitch

magic loop: Magic loop

A way to knit a small tube on one long circular needle. It does the work of double-pointed needles for socks, sleeves, mittens and the top of a hat.

Stitch count
The stitch count stays the same. It is a way of holding the stitches, not a stitch.
Also written
magic loop method, ML

How to work it

  1. Cast on with a circular needle that has a long, flexible cable: 32 inches (80 cm) or more.
  2. Slide the stitches onto the cable. Find the middle of them, bend the cable there and pull a loop of cable out between the two halves.
  3. Slide each half up onto a needle tip. Hold the two tips side by side, pointing to the right, with the working yarn hanging from the back needle. Check that the cast-on edge is not twisted around the needles.
  4. Pull the back needle out to the right until its stitches rest on the cable. With that needle, knit the stitches on the front needle. The first stitch closes the round: pull it snug.
  5. Turn the work. Slide the stitches now in front up onto their tip, pull the other tip out so that the stitches just worked rest on the cable, and knit across the front needle again.
  6. When both halves have been worked, one round is done.

Good to know

  • A loop of cable sticks out at each side of the work. That is how it should look.
  • Pull the yarn snug on the first two stitches of each half, or a ladder of loose strands forms where the halves meet.
  • A marker at the very start of the round falls off the needle tip. Place it a stitch or two in, or let the cast-on tail mark the start.

Reading a pattern?

Rowly keeps your place in the pattern, row by row.

Try Rowly